Method of ground stone carving machine

On stone carving machine other information please visit http://www.shyidiao.com/ for more details.

Grounding way to avoid stone engraving machine caused by electric leakage electric shock risk, but also can effectively prevent electrostatic interference. Stone engraving machine manufacturers the following detailed explanation of what measures on stone carving machine ground wire.
1, prepare 3 3*30 2.5 meters long steel, dig 3 30 cm deep hole in the air, a distance of 3 meters, and then the angle steel piling into the ground; use 3*30 hot galvanized flat steel with welding connect them together, request to lap welding.
2, use the measuring instrument measuring network of the resistance. The resistance is zero or at less than 4 ohm, can reach below 4 ohms, clarify is qualified to install the ground, you can rest assured from the above ground wire leads.
3, in the lead out flat iron top drill a hole of 8mm, Kong Sizhou Cuo Jiejing, then tighten the wire and flat iron.
4, the last is that the wire slot wire into the user, increase the network inside a safe grounding wire.
Above is the stone carving machine grounding way, hope for the stone carving machine using bring peace guarantee. If you want to understand more relevant knowledge of stone engraving machine, please contact with our company.