About DIY engraving machine the other information please visit http://www.shyidiao.com/ for more details.
DIY engraving machine suggested that the fabric brush and good average pressure in the indented upward mould, tank is full, then the fabric average brush at the surface, laying the first layer of glass fibre cloth, brush the glass cloth and the board surface of the fabric full contact with the iron wire, flat on the glass cloth on put the ingredients, and then, with the plate after leveling and then square trowel close to the wire pressing, the thickness of the average divergence, remove the iron, laying of second layers of glass fibre cloth, plate for erase it, put on the fabric with plate trowelling, put a third layer of glass cloth plate, with smooth, make the fabric and glass cloth to dry in prison, DIY engraving machine is recommended in the air temperature is at 25 DEG C, 24 h can die. After the introduction of spray dried D boring 3-5 application. DIY engraving machine recommend this product quality raw material compatibility components proportion range is: Magnesium Oxide 3.0-3.3 1.2 a 1.5, talcum powder, magnesium chloride 3.5-4.0, 0-1. wood flour 1 4, 107 0.2 0.3 glue, glass cloth 0.3-0.4. Product applications this product is building decoration materials, can be used for indoor wall decoration. Method of use: the piece of wood is fixed on the wall, with a rubber brush in the composite carved decorative board and batten, until the glue is slightly dry can be compacted into decorative board. DIY engraving machine recommend this product raw material source is common, low cost, has the advantages of scientific design, reasonable process, beautiful decoration, the effect is good, can fire proof, no deformation, long life.